I have covered most show commands throughout the previous topics. Therefore I will list them quickly here plus a few others:
- show ip interface brief
- show flash:
- show running-config
- show mac-address-table
- show vlan
- show vlan brief
- show interface switchport
- show interface trunk
- show vtp status
- show vlan
- show spanning-tree summary
- show spanning-tree
As I’m using PacketTracer there isn’t much in terms of debugging commands for switches. I would highly recommend using physical switches if possible and build a small network and run some debug commands.
This might be useful – command reference from a Cisco Catalyst 2950 switch.
*If there is anything you’d like to add or feel there’s a mistake, please feel free to comment and contribute.